Outdoor drop fuse is suitable for up to and including 35 kv voltage frequency 50 hz in the power system, transmission lines, power transformer overload and short circuit protection, only device.the rated load current, a mechanical life 2000 times or more
Drop type fuse and tensile load falling type fuse is outdoor high voltage protection appliances, it assembled in distribution transformer high voltage side or distribution lines trunk road, transmission lines, power transformer overload and short circuit protection and device.the rated load current. According to fuse protection, the large amount of open circuit current should be no less than the maximum short-circuit current of protected electrical circuit;Minimum melting current should be no greater than was the minimum short circuit current protection circuit.
When installing fuse, should tighten all of the parts, to prevent contact part overheating during normal operation.
For three-phase install fuse piece, even if an action, the other two shall be replaced, because the other two, though not damaged, but is close to a point, to the extent of the damage.Vacuum fuse
Fuse cannot be installed on the severe vibration, dust, pollution, moist places.
The fuse save and check the fuse installation and replacement
To fall or the vibration of the fuse should be tested before use (dc resistance, the parts are in good condition)
Place a long time of fuse factory/outbound should be check again when the resistance value.
Fuse should be stored in dry places.
In replacement of fuse piece, should be replaced in the action after 10 minutes. If after fusing a movement found smoke emission tube or noisy phenomenon, should not replace the fuse, need, fusing and isolation are allowed to change after a power source.
For in near the power supply device or a charged conductor, should meet the safety regulations
1.ISO9001,C
2.90%exportation
3.good quality and reasonable price
Product Description
Outdoor Fuse Cutout 10KV-36KV
Application: Protection device for protecting power system from over-load and short-circuit failure.Â
Ratings: 10kV-36kV.Â
Standards: IEC 600282-2
Features:Â
1, High over-current protection capability, high breaking current.Â
2, High industrial frequency withstands voltage, and mechanical strength, etc.Â
3, High quality on strict testing.Â
Technical Data:Â
Rated voltage: 11kV to 66kV.Â
Rated current: Up to 200A.Â
main technical parameters
Â
Â
 TYPE |
 Rated Voltage (KV) |
 Rated Current (A) |
 Breaking Current (A) |
 Impulse Voltage (BIL) (KV) |
 Power-frequency wishtand voltage (KV) |
 Leakage Distance (MM) Voltage |
 Weight (KG) |
 Dimensions (CM) |
RW3 | 10 | 100 | 6300 | 100 | 42 | 230 | 6.2 | 48X27X12 |
RW3 | 10 | 200 | 8000 | 100 | 42 | 230 | 6.5 | 48X27X12 |
HRW3 | 10 | 100 | 6300 | 100 | 42 | 230 | 6.2 | Â |
HRW3 | 10 | 200 | 8000 | 110 | 42 | 230 | 6.2 | Â |
RW7 | 10 | 100 | 6300 | 110 | 42 | 230 | 6.2 | 48X27X12 |
RW7 | 10 | 200 | 8000 | 110 | 42 | 230 | 6.5 | 48X27X12 |
HRW7 | 12 | 100 | 6300 | 110 | 42 | 230 | 6.2 | Â |
HRW7 | 12 | 200 | 8000 | 110 | 42 | 230 | 6.2 | Â |
RW10-10F | 12 | 100 | 6300 | 110 | 42 | 260 | 7.5 | 53X32X12 |
RW10-10F | 12 | 200 | 8000 | 110 | 42 | 260 | 7.5 | 43X32X12 |
HRW10 | 12 | 100 | 6300 | 110 | 42 | 260 | 7.5 | Â |
HRW10 | 12 | 200 | 8000 | 110 | 42 | 260 | 7.5 | Â |
RW12 | 15 | 100 | 10000 | 110 | 40 | 250 | 7.5 | 40X34.5X11 |
RW12 | 15 | 200 | 12000 | 110 | 40 | 250 | 7.5 | 40X34.5X11 |
RW12 | 24 | 100 | 8000 | 150 | 65 | 540 | 12 | 49X35X14 |
RW12 | 24 | 200 | 12000 | 150 | 65 | 540 | 12 | 49X35X14 |
RW12 | 30 | 100 | 6000 | 170 | 70 | 700 | 15 | 56X38X14.5 |
RW12 | 30 | 200 | 8000 | 170 | 70 | 700 | 15 | 56X38X14.5 |
RW12 | 33 | 100 | 10000 | 170 | 70 | 720 | 15.5 | 57X38X14.5 |
RW12 | 33 | 200 | 12000 | 170 | 70 | 720 | 15.5 | 57X37X14.5 |
RW12 | 11 | 100 | 6000 | 110 | 42 | 340 | 7.5 | 49X27X11.5 |
RW12 | 11 | 200 | 8000 | 110 | 42 | 340 | 7.5 | 49X27X11.5 |
RW11 | 36 | 100 | 6000 | 110 | 42 | 340 | 16 | 90X40X13 |
RW11 | 36 | 200 | 8000 | 170 | 70 | 870 | 16 | 90X40X13 |
RW5 | 33 | 100 | 8000 | 170 | 70 | 820 | 27.5 | 67X17X15 |
RW5 | 33 | 200 | 10000 | 170 | 70 | 820 | 27.5 | 68X17X15 |
HRW9 | 10 | 100 | 6300 | 110 | 42 | Â | Â | Â |
HRW9 | 10 | 300 | 8000 | 110 | 42 | Â | Â | Â |
HRW11 | 12 | 100 | 6300 | 100 | 42 | Â | Â | Â |
HRW11 | 12 | 200 | 8000 | 110 | 42 | Â | Â | Â |
HPRW11 | 12 | 100 | 6300 | 100 | 42 | Â | Â | Â |
HPRW11 | 12 | 200 | 8000 | 110 | 42 | Â | Â | Â |
HRW12 | 12 | 100 | 6300 | 100 | 42 | Â | Â | Â |
HRW12 | 12 | 200 | 8000 | 110 | 42 |
Led Fresh Light main applying: Super Market , vegetable markets , Living Room, Factory, Commercial Lighting, Indoor Lighting .
Shen Zhen Exceed Electronic CO., LTD" was established in 1999. Exceed Electronic has thrived to be one of the leading manufacturers and exporters of LED products.
Our business range mainly covers LED Light, LED Lamp , High Power LED Light, High Power Big LED Bulb Light, Led Panel Light , LED Ceiling Light , Led Tube Light , Eye Protecting LED Table Lamp ,Body Sensor Led Bed Light ,LED Digit Display, LED Dot Matrix, LED Flame Light , Led Solar Energy Light etc.
Application: Home/ Meeting Room/ Hotel/ School/ Factory/ Hospital/ Indoor Lighting, etc
Led Low Bay Light Detail:
Light Source: COB
Item Type: Led Low Bay Light
LED Light Source: COB
Warranty(Years): 50w 30w 20w
Input Voltage(V): AC85-265V
Lamp Luminous Flux(lm): 3500lm-24000lm
degree :60°
CRI (Ra>): 70
Color Temperature(CCT): 2700K-7000K
Working Temperature(℃): -20 - 40
Working Lifetime(Hour): 50000
Lamp Body Material: Aluminum
IP Rating: IP44
Certification: CE, RoHS
Brand Name: Exceed
Product name: High Power LED Low bay light
Frame Color: Red Blue ,Yellow ,Green ,Black
Delivery Time: 7-10days after receipt of advance payment
Led Fresh Light
Led Fresh Light,Led Low Bay Light,Color Led Fresh Light,Black Led Low Bay Light
Shen Zhen Exceed Electronic Co., Ltd. , http://www.exceedlight.com