Intelligent Home Furnishing Smart Electric Curtain Installation Experience Sharing

With the continuous popularization of the concept of intelligence, not only smart terminals have been used on a large scale, but some smart home products have also appeared quietly in the homes of many consumers, and electric curtains are a smart single product in smart home curtain systems. So, how to install and use electric curtains?

Electric curtain installation is very simple, but for inexperienced installation companies, there are still many places to learn. Here we share some of our company's accumulated experience. Hope to be helpful to everyone.

First of all, after we have received an order for electric curtains, we have to communicate with the electrician on site to determine the location of the motor, the lines that need to be rebuilt, etc. Here we need to point out that for the lifting motor, the circuit should pay attention. There are two options. First, from the position of the curtain box to the point one meter away from the ground, take the middle point out. In this way, when not lifting, the line is against the wall to the motor position.

The second is the use of spring wire, from the top outlet. This applies to the situation where power is not changed on site and power is only left at the top. In this way, no obvious lines will be revealed from below.

Second, we must keep the width of our curtains. Usually 200MM or more of two tracks within four meters is enough. If the track length exceeds four meters or the window has an opening, the corresponding number of centimeters must be increased. It's enough to stay at 260MM. If we add the lifting system, we also consider the offset when lifting, generally leaving 300MM wide.

Once again, our line was OK, so we customized the curtain track and installed it on site. The length of the curtain box and the length of the track must be measured before installation. See if they match. (The track is 3 to 5 cm shorter than the curtain case.) After the size is measured, the line is drawn on site to set the installation code position. Then fix it with a self-tapping screw (bullet in the original top).

Then, the installation of the track is the installation and commissioning of the motor. It is necessary to pay attention to the processing of the motor connection. Do not allow the line to run anywhere, and do not leave it too long. If the wire coming out from the top is to be in close contact with the motor, it can be handled with a tie.

Finally, the construction master who reminded the curtain cloth art must pay attention to a hook on the side of the motor when hanging the curtains. The first hook should be hung there. Otherwise, the motor will be exposed, affecting the overall appearance.